JS Oxygen Probe - For Use In Flues & Boilers Get latest price

Read more...

To contact Ceramic Oxide Fabricators (Australia) about JS Oxygen Probe - For Use In Flues & Boilers use Get a quote.

The JS C700 Oxygen Probe incorporates a heater to maintain the sensor at its working temperature, even if the gas is at a much lower temperature.

The features of the JS probe include:

• Heater sealed in a stainless steel can, isolating it from corrosive flue gases.
• Porous stainless steel filter to minimise dust build-up on the sensor.
• Gas inlet for calibration gases.
• Purge facility, to clean the filter in-situ.
• Modular construction for simple maintenance.
• Compact design, allowing installation in small or large flues.
• Integrated thermocouple, enabling accurate temperature control of the heater.

JS C700 Oxygen Probe Features

• Specific for O2
• High O2 sensitivity and selectivity
• High dynamic range of detection
• High temperature of operation
• Rapid responses
• In situ measurement
• Solid state electronic component – rugged sensor
• 240 VAC 50-60 Hz or 110 VAC 50-60 Hz
• Available up to 1000 mm
• Purge air

Applications:

• Fuel combustion efficiency control
• Furnace gas analysis
• Waste management systems
• Flue gas analysis
• O2 levels at high temperatures
• CO2 harsh environments

The JS probe requires a separate user-supplied instrument panel providing power and temperature control for the heater, purge timing and purge gas.

Please note that above 850 °C the probe will experience irreparable damage.

This probe can be ordered in a range of different sizes in steps of 100 mm, and with a K-Type thermocouple.

For more information please call or use the IndustrySearch enquiry box for a direct reply.

Read less...

To contact Ceramic Oxide Fabricators (Australia) about JS Oxygen Probe - For Use In Flues & Boilers use Get a quote.