Ashing Furnace 1000°C Get latest price

Read more...

To contact Sietronics Pty Ltd about Ashing Furnace 1000°C use Get a quote.

The furnaces are strongly constructed of zinc coated steel powder coated Wedgewood blue with Hi Temp black front face and door. The muffle is strongly supported by a refractory mould at the front and insulating bricks at the back. It is insulated with ceramic fibre and firebricks. The steel cover around the muffle is surrounded by an air cavity and by gravity convection draws heat away from the bottom and out through the top reducing the wall temperature of the outer body. An air gap at the front and louvres on back panel allow adequate air flow to ensure a cool instrument panel. All cantilever door furnaces are fitted with a door switch for safety.

Air exhaust is through an adjustable 50mm vent on top of the furnace. Airflow is up to 20 exchanges per minute at 800°C. The air inlet is through two vent tubes at the back of the furnace allowing air to pass over the external surface of the muffle through channels in the insulating bricks and into the working chamber via a gap at the top of the muffle. This gives a preheated airflow to maintain an even temperature. The heating section of muffle is set back from the door face approximately 70mm to give an even temperature from front to back of working area. The outer case is kept to minimum temperature by a surrounding air cavity.

Kanthal A1 Element is controlled by a microprocessor based PID controller complete with Auto Tune function and sensor compensation for accurate temperature control. An overtemp cutout is also provided as a standard feature.

Furnace Details

*Applies to uniform zone within 30mm of back & 70mm from front edge of muffle liner.

Read less...

To contact Sietronics Pty Ltd about Ashing Furnace 1000°C use Get a quote.